Parameter Pages Overview - Theben KNX Series Handbook

Parameter pages overview

4.4
The device consists of one general block and 4 main functional blocks.
Parameter page
General functional block
General
Measurement values
RTC functional block
Setting
Actual value
Operating Mode
Heating control
Heating set points
Additional stage
heating
Cooling control
Cooling set points
set point adjustment
Additional stage
cooling
External inputs functional block
Channel I1
Channel I2
Channel I3
Channel I4
Switch object 1
Switch object 2
Switch object 3
Button object 1
Button object 2
Button object 3
Dimming
Blinds
Double-click
Only RAMSES 718 P
9
RAMSES 718 P / RAMSES 718 S
Description
LED settings, activation of the temperature sensor inputs.
Setting for temperature measurement (internal sensor)
General settings to operate
Source for actual value measurement, actual value monitoring, etc.
Operating mode after reset, presence sensor etc.
Control parameters, installation type etc. for heating mode.
Base set point value, lowering, frost protection etc.
Type of actuating value, proportional band, transmission behaviour.
Control parameters, installation type etc. for cooling mode.
Dead zone, standby, heat protection etc.
Setting maximum adjustment.
Type of actuating value, proportional band, transmission behaviour.
Function of the input, debounce time, number of telegrams, block
function, etc.
Additionally at I3 and I4: Selection of the temperature sensor,
temperature calibration, etc.
Object type, transmission behaviour, etc. can be set for each object
individually.
Object type, transmission behaviour, etc. can be set for each object
individually.
Type of control
Type of control
Additional telegrams for dimming and blinds
The application programmes RAMSES 718 P/S
and temperature control
9
33