Viewing An Image From A Pc; Connecting A Pc; Displaying An Image From A Pc - Sharp Aquos LC 37HV6U Operation Manual

Using external equipment

Viewing an image from a PC

Connecting a PC

Use the PC terminals to connect a PC.
NOTE
• The PC input terminals are DDC1/2B-compatible.
• Refer to page 77 for a list of PC signals compatible with the System.
AVC System (front view)
Signal names for 15-pin mini D-sub connecter
5 4 3 2 1
10 9 8 7 6
15 14 13 12 11
NOTE
• Macintosh adaptor may be required for use for some Macintosh computers.
TV
POWER
AV
MODE
NOTE
• Each time INPUT is pressed, the input source toggles.
46
RGB cable
(commercially available)
ø 3.5 mm stereo minijack cable
(commercially available)
Pin No.
1
2
3
4
Not connected
5
TV CBL VCR DVD
/SAT /LD
/DTV
ANT-A/B INPUT
Virtual
MTS CC
Display
INPUT button
Signal name Pin No.
6
R
7
G
8
B
9
0
CSYNC

Displaying an image from a PC

To view an image from a PC, select "PC" from the
"INPUT SOURCE" menu using INPUT on the remote
control unit or on the Display. (See page 52.)
When connecting to a PC, the correct input signal type
is automatically detected. If the PC image does not
come in clearly, you may need to set the Auto Sync.
adjustment on the "Auto Sync." in the "Setup" menu.
(See page 51.)
You only need to select the input source on the "INPUT
SOURCE" menu.
PC
Signal name Pin No.
q
GND (Ground)
w
GND (Ground)
e
GND (Ground)
r
5V
t
GND (Ground)
INPUT SOURCE
TV
INPUT1
INPUT2
INPUT3
INPUT4
PC
Signal name
Not connected
SDA
HD
VD
SCL