Viewing An Image From A Pc; Connecting A Pc; Displaying An Image From A Pc - Sharp AQUOS LC-37HV4U Operation Manual

Using external equipment

Viewing an image from a PC

Connecting a PC

Use the PC terminals to connect a PC.
NOTE
• The PC input terminals are DDC1/2B-compatible.
• Refer to page 77 for a list of PC signals compatible with the System.
AVC System (front view)
Signal names for 15-pin mini D-sub connecter
5 4 3 2
10 9 8
15 14 13 12
NOTE
• Macintosh adaptor may be required for use for some Macintosh computers.
46
Downloaded from: http://www.usersmanualguide.com/
ø 3.5 mm stereo minijack cable
(commercially available)
Pin No.
1
1
7 6
2
11
3
4
5
TV CBL VCR DVD
/SAT /LD
TV
/DTV
POWER ANT-A/B INPUT
AV FRONT
MODE SURROUND MTS CC
TWIN
PICTURE SELECT
VIEW SUB TWIN CH
MODE FREEZE INPUT
DISPLAY SLEEP LEARN
EDIT/
INPUT SOURCE
TV
INPUT1
INPUT2
INPUT3
INPUT4
PC
RGB cable
(commercially available)
Signal name Pin No.
6
R
7
G
8
B
9
Not connected
0
CSYNC

Displaying an image from a PC

To view an image from a PC, select "PC" from the
"INPUT SOURCE" menu using INPUT on the remote
control unit or on the Display. (See page 50.)
When connecting to a PC, the correct input signal type
is automatically detected. If the PC image does not
come in clearly, you may need to set the Auto Sync.
adjustment on the "Auto Sync." in the "Setup" menu.
(See page 49.)
You only need to select the input source on the "INPUT
SOURCE" menu.
NOTE
• Each time INPUT is pressed, the input source toggles.
PC
Signal name Pin No.
q
GND (Ground)
w
GND (Ground)
e
GND (Ground)
r
5V
t
GND (Ground)
Signal name
Not connected
SDA
HD
VD
SCL