Simple Button Operations For Changing Channels - Sharp Aquos LC 37HV6U Operation Manual

Watching TV
Simple button operations for
changing channels
You can change channels in several ways.
NOTE
• While watching a broadcast, press ANT-A/B to view the
image received from the other tuner.
TV CBL VCR
/SAT
TV
/DTV
POWER ANT-A/B
AV Virtual
MODE
TWIN
PICTURE
VIEW
MODE FREEZE
DISPLAY SLEEP
1 2
4 5
7 8
0
FLASHBACK
VOL
MUTE
I Using CHa/b on the remote control unit
• Press CHa a a a a to increase the channel number.
• Press CHb b b b b to decrease the channel number.
NOTE
• CH s/r on the Display operates the same as CHa a a a a /b b b b b
on the remote control unit.
Display
CH s/r
I Changing channels with CH a/b on the
remote control unit or CH s/r on the
Display
Air: Press CH a and the channel change in the
order shown below:
2s3s...s68s69s2s3...
Press CH b and the channel change in the order
shown below:
3s2s69s68s...s3s2...
Cable:Press CH a and the channel change in the
order shown below:
1s2s3s...s125s1s2s3...
Press CH b and the channel change in the order
shown below:
3s2s1s125s...s3s2s1s...
DVD
/LD
INPUT
MTS CC
SELECT
SUB TWIN CH
INPUT
LEARN
EDIT/
3
6
9
100
ENT
CH
I Using FLASHBACK on the remote control
unit
Press FLASHBACK to switch the currently tuned
channel to the previously tuned channel.
Press FLASHBACK again to switch back to the
currently tuned channel.
NOTE
• FLASHBACK will not work if no channel has been
changed after the System is turned on.
I Using 0 – 9 and 100 on the remote control
unit
Select the channels directly by pressing buttons 0 to
9 and 100.
• The System allows you to select up to 125 channels
(1 to 125). To select a channel, enter a 2 or 3-digit
number.
a
To select a 1 or 2-digit channel number
(e.g., Channel 5):
Complete the following steps within 3 seconds.
1
Press the 0 button.
• Complete the step 2 within 3 seconds after the
step 1.
2
Press the 5 button.
NOTE
• When selecting a 1-digit channel number, do not fail to
press the 0 button.
To select a 3-digit channel number
(e.g., Channel 115):
Complete the following steps within 3 seconds.
1
Press the 100 button.
• Complete the step 2 within 3 seconds after the
step 1.
2
Press the 1 button.
• Complete the step 3 within 3 seconds after the
step 2.
3
Press the 5 button.
NOTE
• The 100 button is only enabled when selecting channels
in Cable mode.
0 –
5
1 – –
11 –
115
23