Setting The Avc System With The Stand; Setting The Display On The Wall - Sharp Aquos LC 37HV6U Operation Manual

Preparation

Setting the AVC System with the stand

How to install the AVC System vertically using the stand unit.
• Use the supplied stand unit for installing the AVC System vertically in an upright position.
Stick each spacer to the
1
stand as shown.
Peel each spacer
away from the
paper and attach
to the four bulging
areas on the stand.
Bulge
Attach the stand using the
4
stand screws as shown.
NOTE
• When mounting the AVC System vertically, always use the supplied stand. Be careful not to block vent holes when
standing up directly on the floor or a flat surface as this can result in equipment failure.

Setting the Display on the wall

CAUTION
• Installing the Liquid Crystal Television requires special skill that should only be performed by qualified service
personnel. Customers should not attempt to do the work themselves. SHARP bears no responsibility for
improper mounting or mounting that results in accident or injury.
Using an optional bracket to mount the Display
• You can ask a qualified service personnel about using an optional AN-37AG1 bracket to mount the Display
to the wall.
• Carefully read the instructions that come with the bracket before beginning work.
Hanging on the wall
AN-37AG1 wall mount bracket. (See the bracket instructions for details.)
Vertical mounting
Attach each cushion to
2
the stand as shown.
Peel each cushion
away from the
paper and attach
Stand
to the four areas at
spacer
the bottom.
Bulge
Attaching point
The AVC System installed
vertically with the stand.
Stand screw
Fit the stand to the AVC
3
System.
Insert the stand into the AVC
System, making sure that the
thick and thin bulges of the
stand align with the big and
Stand cushion small holes on the AVC
System.
Attaching point
Small
hole
About setting the Display angle
• You can set the Display on the
wall up to 5 degrees forward
when the speaker is attached and
up to 20 degrees forward when
the speaker is not attached. Do
not set the angle outside those
ranges.
Angular mounting
Thin bulge
Thick
bulge
Big hole
5°
11