Siemens Sinumerik 802D sl Instruction Manual page 194

Data Backup and Series Machine Start-Up
12.2 Series machine start-up
Sequence with CF card
1. Creating a series machine start-up file on the CF card:
– Make sure that the CF card is inserted in the slot on the device front panel.
– The control system requires the password for protection level 2.
– In the System > Start-up files > 802D data menu, select the Start-up archive (NC/
2. Reading in the series start-up file from the CF card into the SINUMERIK 802D
– Make sure that the CF card is inserted.
– The control system requires the password for protection level 2.
– In the System > Start-up files > Customer CF card menu, select the line containing
– Once reading-in has started, confirm the start of the series machine start-up in the
– A warm start of the NC/PLC is performed several times during the series machine
Start-up archive (HMI)
This data backup is created analogously to the start-up archive (NC/PLC). For creation and
reading in, select System > 802D data > Start-up files > Start-up archive (HMI).
12-192
PLC) line and use the Copy command to paste the contents to the clipboard. Select
the Customer CF card softkey to display the contents of the inserted card. If you se-
lect the Paste softkey and subsequently enter the name for the archive file, the series
machine start-up is produced on the card.
the appropriate archive and use the Copy command to paste the data to the clipbo-
ard. Select the 802D data softkey and select the "Startup data (NC/PLC)" line. Selec-
ting the Paste softkey will transmit the series start-up to the control system.
control system.
start-up. At the end of the series machine start-up, the whole control system will re-
boot (warm start). After an error-free series machine start-up, the control system will
be in a fully configured operating condition.
SINUMERIK 802D sl Instruction Manual (BA), 05/2005 Edition
6FC5 397-0CP10-1BA0