Xerox Phaser 3635MFP Service Manual page 124

5. Measure the distance between the left edge of the paper and the ADG line on the printed
test pattern, Figure 1.
Figure 1 Test pattern 7
6. If the distance measured is not 12.7mm (0.5 inch) +/-2.5mm, perform the Adjustment.
Adjustment
1. Select Exit (on the dC606 Internal Print Test Patterns (3635
2. Select Diagnostic Routines.
3. Select Copier Routines.
4. Select 131 NVM Read Write.
5. Refer to Table 1. Select the relevant NVM setting.
Table 1 NVM location
Mode Tray
Simplex 1
Simplex 2
Simplex Bypass
Duplex Side 1 1
Repairs and Adjustments
ADJ 8.2
Only).
Location
07-110
07-210
07-510
07-150
Table 1 NVM location
Mode Tray
Duplex Side 1 2
Duplex Side 1 Bypass
Duplex Side 2 1
Duplex Side 2 2
Duplex Side 2 Bypass
6. Select Read/Write. Enter a new value as follows:
• To increase the side edge registration (move the ADG line away from the paper
edg)e, enter a value larger than the current value.
• To decrease the side edge registration (move the ADG line toward the paper edg)e,
enter a value smaller than the current value.
NOTE: A change of 12 will change the registration by approximately 6mm (0.24
inch)
7. Save the adjustment.
a. Select Save.
b. Select OK.
8. Prepare to check the adjustment.
a. Select Close.
b. Select Diagnostic Routines.
c. Select Other Routines.
9. Perform again the 3635 Checkout.
3550 Checkout
NOTE: Both the Check and the Adjustment use an internal test pattern. Both are performed in
diagnostics.
Check the side edge registration (left side edge of portrait A4 or 8.5x11 inch). Perform the fol-
lowing:
1. Enter diagnostics GP 1 Diagnostics
2. Select machine diagnostics.
3. Select dC606 Internal Print Test Patterns (3635
4. Select Test Pattern 7 for simplex side edge check or select Test Pattern 15 for duplex
side edge check.
5. Press the O.K button to print the chosen test pattern.
NOTE: Simplex copies exit face down. Duplex copies exit side 1 face down (side 2 face
up).
April 2010
4-52
Location
07-250
07-550
07-130
07-230
07-530
Entry.
Only).
Phaser 3635MFP/WorkCentre 3550