Rep 7.5 Bypass Paper Empty Sensor - Xerox Phaser 3635MFP Service Manual

REP 7.5 Bypass Paper Empty Sensor

Parts List on PL 7.10
Removal
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Before performing this procedure, refer to
1. Remove the DADF, PL 5.10 Item 1.
2. 3635 only. Remove the UI assembly,
3550 only. Remove the UI assembly,
3. Remove the scanner assembly, REP
4. Remove the left cover, right cover and rear cover,
5. Remove the front cover assembly, PL 28.10 Item
6. Remove the outbin assembly, REP 28.2.
7. Remove the front mid cover, REP 28.3.
Phaser 3635MFP/WorkCentre 3550
CAUTION
GP 10 General Disassembly Precautions.
REP 2.1.
REP 2.3.
14.1.
REP 28.1.
7.
8. Remove the bypass paper empty sensor,
2
Remove the bypass paper
empty sensor
Replacement
1. Replacement is the reverse of the removal procedure.
2. If the harness is tight it may be necessary to remove the bypass feed assembly
to allow sufficient slack to reinsnstall the sensor.
April 2010
4-23
Figure 1.
1
Press down on the tab, then
slide out the sensor bracket.
Figure 1 Sensor removal
Repairs and Adjustments
(REP 7.1)
REP 7.5