Rep 10.4 Exit Roll And Exit Idler Assemblies - Xerox Phaser 3635MFP Service Manual

9. Remove the front duplex guide assembly,
1
Remove the
clamp.
4
Remove the front duplex
guide assembly.
Figure 2 Front duplex guide assembly removal
10. If necessary remove the tray 1 paper empty sensor,
guide.
Replacement
1. Replacement is the reverse of the removal procedure.
Phaser 3635MFP/WorkCentre 3550
Figure 2.
2
Remove 2 screws.
3
Disconnect the
connector.
PL 10.22 Item 1 from the front duplex

REP 10.4 Exit Roll and Exit Idler Assemblies

Parts List on PL 10.25
Removal
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Before performing this procedure, refer to
1. Remove the DADF, PL 5.10 Item
2. Remove the left cover, right cover and rear cover,
3. 3635 only. Remove the UI assembly,
3550 only. Remove the UI assembly,
4. Remove the scanner assembly,
5. Remove the exit cover assembly,
6. Remove the exit roll, PL 10.25 Item
7. Remove the idler assembly,
Replacement
1. Replacement is the reverse of the removal procedure.
April 2010
4-31
WARNING
CAUTION
GP 10 General Disassembly Precautions.
1.
REP 28.1.
REP 2.1.
REP 2.3.
REP 14.1.
PL 28.10 Item 2.
22.
PL 10.25 Item 21.
Repairs and Adjustments
REP 10.3, REP 10.4