Table of Contents
Advertisement
Section 2
Unit Specifications
General specifications
Characteristic
Supply voltage
Current consump-
tion
Dimensions
Protection rating
(IEC 60529)
Operating ambient
temperature
Operating ambient
humidity
Storage ambient
temperature
Storage ambient
humidity
Mounting system
24 V power terminals/setup DIP-SW
Open the cover to access 24 V power terminals and setup DIP-SW.
24 VDC
• For wiring connections, use
compression rings.
• Use the M3 compression
rings illustrated below.
6 mm max.
6 mm max.
• Recommended 24 V power supply: Model S82K-03024 (OMRON)
• Set the RS-485 terminator setting to ON for the link units on both ends of multidrop, and to OFF for
other units. If only one link unit is operated, set the terminator setting to ON.
Wrong wiring connection can lead to a malfunction of the equipment. Be fully sure of the correct
wiring connections.
V700-L11
24
User's Manual
Specification
24 VDC, +10%, −15%
250 mA max.
110 × 65 × 64 mm
IP20
0 to +40°C
35 to 85%RH
−15 to +50°C
35 to 85%RH
Secured with two M4 screws.
ON
1
2
3
4
5
SW
No.
1
2
3
4
5
6
7
8
9
10
Supplied from the power terminals
Approx. 10 A max. with rush current
Except for mounting hook
No freezing
No dew condensation
No freezing
No dew condensation
6
7
8
9
10
Description
(Content within a box
Node No. 1
01 to 31
No. 1 is LSB, and No. 5 is MSB.
Node No. 2
(For correspondence between DIP-SW settings
Node No. 3
and node Nos., see the table in the next page.)
Node No. 4
Node No. 5
Baud rate setting 1
38400/ 9200/ 9600 /4800bps
[ON,ON] [ON,OFF] [OFF,OFF] [OFF,ON]
Baud rate setting 2
:[No7,No6]
Reserved
Always leave in OFF position.
Reserved
Always leave in OFF position.
RS-485 terminator
ON/ OFF
Comment
Meaning
represents factory-setting)
Advertisement
Table of Contents
