Table of Contents
Advertisement
3.4 Room transfer
3.4.1 Room transfer with 2 hoists
Room transfer can be done by using two Robin hoists; one in each room. To ease this operation, an Invacare
room-to-room trolley is used.
Room transfer is possible in both single- or room covering installations. It is important that the rails are located
as close to the doorway as possible. When installing a room covering rail system intended for room transfer, the
traverse rail must be installed perpendicular to the wall with the doorway. The distance between the two end stop
buffers must not exceed 60 cm. To obtain the best possible result during room transfer, there must be a minimum
distance of 185 cm between the floor and the underside of the hoist. This must be kept in mind during installation
of the rail system.
3.4.2 Room transfer with coupling
As an alternative the room transfer can be achieved (remove by) an installated transit coupling.
The coupling can be used to connect either two traverse systems or one traverse system and one mono-rail
system.
The coupling is operated electrically by a control button mounted on the wall.
The coupling is delivered with a standard length of 800 mm.
For further information see section 4.14 and 5.9.
9
Advertisement
Table of Contents
