Table of Contents
Advertisement
5.6 Wall support leg
Wall support leg are used for installation on gypsum walls and walls of other
lightweight plate material.
1. Wall support leg profile (adjust length).
2. Support console.
3. Wall support foot.
4. Plastic cover plugs.
5. Screws M6.
The wall support leg is cut in the right length, in the end facing against the floor.
When measuring the profile length, include a minimum distance between the top of
the bracket and the ceiling.
This min. distance must be observed for any of the three rail profiles:
•
M-profile: min. 80 mm.
•
L-profile: min. 150 mm.
Mount the wall support leg on the wall with three screws. Use Ø6 mm screws. The wall material determines the
choice of screws.
For mounting into gypsum, we recommend using Hilti HGA sheer connector for cavities.
NOTE! Remember to make allowance for the wall support foot.
In case of skirting boards, either use the high wall support foot or cut the skirting boards.
NOTE! Always install wall support leg directly on the wall in their full length.
See section 5.6 for further details.
28
Advertisement
Table of Contents
