Watch-Net And Watch-Net-All Diagnostics - Sun Microsystems Sun Blade 150 Service Manual

keyboard. The watch-clock diagnostic is initialized by typing the
watch-clock command at the ok prompt. The following code example shows the
watch-clock diagnostic output message.
CODE EXAMPLE 4-1
ok watch-clock
Watching the 'seconds' register of the real time clock chip.
It should be 'ticking' once a second.
Type any key to stop.
49
ok
4.6.2

Watch-Net and Watch-Net-All Diagnostics

The watch-net and watch-net-all diagnostics monitor Ethernet packets on the
Ethernet interfaces connected to the system. Good packets received by the system
are indicated by a period (.). Errors such as the framing error and the cyclic
redundancy check (CRC) error are indicated with an "X" and an associated error
description. The watch-net diagnostic is initialized by typing the watch-net
command at the ok prompt and the watch-net-all diagnostic is initialized by typing
the watch-net-all command at the ok prompt. The following code example
shows the watch-net diagnostic output message.
watch-net-all diagnostic output message.
CODE EXAMPLE 4-2
ok watch-net
Internal loopback test -- succeeded.
Link is -- up
Looking for Ethernet Packets.
'.' is a Good Packet. 'X' is a Bad Packet.
Type any key to stop.
............................................................
ok
4-6 Sun Blade 150 Service Manual • June 2002
Watch-clock Diagnostic
Watch-Net Diagnostic Output Message
shows the
CODE EXAMPLE 4-2