Sun Microsystems Sun Blade 150 Service Manual page 107

3. Connect the fan assembly power cable connector to the riser board (J4).
4. Route the cables through the cable retaining clip and close the clip.
5. If you removed any long PCI cards, replace the PCI cards into the riser board.
See Section 8.4.2, "Replacing a PCI Card" on page 8-11.
6. Detach the wrist strap, replace the system cover, and power on the system as
described in Chapter 9.
Chapter 6 Removing and Replacing Major Subassemblies 6-17