Probe-Ide Diagnostic - Sun Microsystems Sun Blade 150 Service Manual

CODE EXAMPLE 4-3
ok watch-net-all
/pci@1f,0/network@c,1
Internal loopback test -- succeeded.
Link is -- up
Looking for Ethernet Packets.
'.' is a Good Packet. 'X' is a Bad Packet.
Type any key to stop.
............................................................
ok
4.6.3

Probe-IDE Diagnostic

The probe-IDE diagnostic transmits an inquiry command to internal and external
IDE devices connected to the system's on-board IDE interface. If the IDE device is
connected and active, the target address, unit number, device type, and
manufacturer name are displayed. Initialize the probe-IDE diagnostic by typing the
probe-ide command at the ok prompt. The following code example shows the
probe-IDE diagnostic output message.
CODE EXAMPLE 4-4
ok probe-ide
Device 0
Device 1
Device 2
Device 3
ok
Watch-Net-All Diagnostic Output Message
Probe-IDE Diagnostic Output Message
( Primary Master )
ATA Model: IC35L040AVER07-0
( Primary Slave )
Removable ATAPI Model: LTN486S
( Secondary Master )
Not Present
( Secondary Slave )
Not Present
Chapter 4 Troubleshooting Procedures 4-7