Watch-Net-All Diagnostic - Sun Microsystems Ultra 2 series Service Manual

The watch-net diagnostic is initialized by typing the watch-net command at the ok
prompt. The following code example identifies the watch-net diagnostic output
message.
CODE EXAMPLE 4-2
{0} ok watch-net
Hme register test --- succeeded.
Internal loopback test -- succeeded.
Transceiver check -- Using Onboard Transceiver - Link Up.
passed
Using Onboard Transceiver - Link Up.
Looking for Ethernet Packets.
'.' is a Good Packet. 'X' is a Bad Packet.
Type any key to stop.
...............
{0} ok
4.6.3

Watch-Net-All Diagnostic

The watch-net-all diagnostic monitors Ethernet packets on any Ethernet interface
installed in the system. For example, if there is an SBus card installed in one of the
system SBus slots, watch-net-all monitors the Ethernet transmissions occurring
through that card. When the test is interrupted by pressing any key, watch-net-all
searches to test the next Ethernet interface card installed in the system.
The watch-net-all diagnostic is initialized by typing the watch-net-all command
at the ok prompt. The following code example identifies the watch-net-all diagnostic
output message.
CODE EXAMPLE 4-3
ok watch-net-all
/pci@1f,4000/network@1,1
Hme register test --- succeeded.
Internal loopback test -- succeeded.
Transceiver check -- Using Onboard Transceiver - Link Up.
passed
Using Onboard Transceiver - Link Up.
Looking for Ethernet Packets.
'.' is a Good Packet. 'X' is a Bad Packet.
4-12 Sun Ultra 2 Series Service Manual • July 1996
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Watch-Net Diagnostic Output Message
Watch-Net-All Diagnostic Output Message