Diag-Level Variable Set To Min - Sun Microsystems Sun Blade 150 Service Manual

CODE EXAMPLE 3-1
PC = 0000.01ff.f000.297c
PC = 0000.0000.0000.29c0
Decompressing into Memory Done
Size = 0000.0000.0006.1780
ttya initialized
Reset Control: BXIR:0 BPOR:0 SXIR:0 SPOR:0 POR:1
Probing upa at 1f,0 pci
Probing upa at 0,0 SUNW,UltraSPARC-IIe (512 KB)
Loading Support Packages: kbd-translator
Loading onboard drivers: ebus flashprom eeprom idprom
Probing Memory Bank #0 256 Megabytes
Probing Memory Bank #1 256 Megabytes
Probing Memory Bank #2 256 Megabytes
Probing Memory Bank #3 256 Megabytes
Probing /pci@1f,0 Device 7
serial
Probing /pci@1f,0 Device c network firewire usb hub keyboard mouse
Probing /pci@1f,0 Device 3
dimm
Probing /pci@1f,0 Device 8
Probing /pci@1f,0 Device d
Probing /pci@1f,0 Device 13
Probing /pci@1f,0 Device 5
Probing /pci@1f,0/pci@5 Device 0
Probing /pci@1f,0/pci@5 Device 1
Probing /pci@1f,0/pci@5 Device 2
Sun Blade 150 (UltraSPARC-IIe 650MHz), Keyboard Present
Copyright 1998-2002 Sun Microsystems, Inc.
OpenBoot 4.6, 1024 MB memory installed, Serial #51602330.
Ethernet address 0:3:ba:13:63:9a, Host ID: 8313639a.
3.6.2

diag-level Variable Set to min

When you set the diag-level variable to min, POST enables an abbreviated set of
diagnostic-level tests. This mode requires approximately one minute to complete
(with 128 Mbytes of DIMM installed).
output with diag-level set to min and a single 512 Mbyte DIMM installed.
3-18 Sun Blade 150 Service Manual • June 2002
diag-level Variable Set to max
storage
dimm dimm ppm beep fan-control
(Continued)
isa dma floppy parallel power serial
pmu i2c temperature card-reader dimm
sound
ide disk cdrom
SUNW,m64B
pci
Nothing there
Nothing there
Nothing there
All rights reserved.
shows a serial port POST
CODE EXAMPLE 3-2