Sun Microsystems Sun Blade 150 Service Manual page 14

Removing the Diskette Drive 7-3
FIGURE 7-2
Removing and Replacing the Smart Card Reader 7-5
FIGURE 7-3
Removing and Replacing a Primary Hard Drive 7-7
FIGURE 7-4
Installing a Secondary Hard Drive 7-10
FIGURE 7-5
Secondary Hard Drive Cabling Configuration 7-11
FIGURE 7-6
Removing and Replacing a CD-ROM or DVD-ROM Drive 7-12
FIGURE 7-7
Removing and Replacing the CPU 8-3
FIGURE 8-1
JP3 OpenBoot PROM Jumper Settings for 650 MHz and 550 MHz CPUs 8-4
FIGURE 8-2
Removing and Replacing the NVRAM/TOD 8-6
FIGURE 8-3
DIMM Installation Order 8-8
FIGURE 8-4
Removing and Replacing a DIMM 8-9
FIGURE 8-5
Removing and Replacing a PCI Card 8-11
FIGURE 8-6
Removing and Replacing the Motherboard 8-14
FIGURE 8-7
JP1/JP2 Jumper Settings for the Flash PROM 8-15
FIGURE 8-8
Removing and Replacing the Riser Board 8-17
FIGURE 8-9
Replacing the System Cover 9-2
FIGURE 9-1
System Power Switch 9-2
FIGURE 9-2
Minimum Clearance for System Cooling A-4
FIGURE A-1
IDE Cabling Configuration A-5
FIGURE A-2
External and Internal Serial Ports A-7
FIGURE A-3
Power Supply Connector J501 Pin Configuration B-2
FIGURE B-1
Secondary Power Supply Connector J505 Pin Configuration B-3
FIGURE B-2
USB Connector J17, J18 Pin Configuration B-4
FIGURE B-3
IEEE 1394 Connector J20, J30 Pin Configuration B-5
FIGURE B-4
TPE Connector J19 Pin Configuration B-6
FIGURE B-5
Serial Port Connector J36 Pin Configuration B-8
FIGURE B-6
Riser Board Serial Port Pinouts (J13) B-9
FIGURE B-7
Accessing the Second Serial Port Through a PCI Card Slot B-10
FIGURE B-8
Serial and Video Port Connector Extensions B-11
FIGURE B-9
Parallel Port Connector J9 Pin Configuration B-12
FIGURE B-10
xiv Sun Blade 150 Service Manual • June 2002