Sun Microsystems Sun Blade 150 Service Manual page 153

Riser board (J504)
FIGURE A-2
FIGURE 1-4
Section 7.3, "Hard Drives" on page 7-6 contains illustrations that illustrates the
cables connected to the hard drives.
A.5.2 CD-ROM and DVD-ROM Jumper Settings
Before you install a CD-ROM or DVD-ROM drive or a hard drive in a Sun Blade 150
system, verify that the drive's back panel mode-select jumper is set as follows:
Set the CD-ROM drive jumper (located on the CD-ROM drive back panel) to either
"CS," "Enable Cable Select," or "Cable Select."
A.5.3 CD Handling and Use
The following topics are discussed in this section:
"Inserting a CD Into the CD-ROM or DVD-ROM Drive" on page A-5
I
"Ejecting a CD From the CD-ROM or DVD-ROM Drive" on page A-6
I
"Cleaning the CD-ROM or DVD-ROM Drive" on page A-6
I
"Handling and Storing CDs" on page A-6
I
A.5.3.1 Inserting a CD Into the CD-ROM or DVD-ROM Drive
1. After the system is powered on, push the eject button on the CD-ROM or DVD-
ROM drive to open the drive tray.
2. Place the CD (label side up) into the drive tray.
Ensure that the CD is properly set into the recessed area of the drive tray.
Riser board (J503)
IDE 2
IDE 1
IDE Cabling Configuration
in Chapter 1 shows the cables separate from the system.
Appendix A Product Specifications and Reference Information
Optional second hard drive
(Secondary HDD)
CD-ROM or DVD-ROM drive
(CD/DVD)
Primary hard drive
(Primary HDD)
A-5