Control Center Setup - York YST Operation Manual

SECTION 3 - PRINTERS
If equipped with HIGH SPEED serial board:
SW1 - off (-) Low when busy
2 - off 1200 Baud*
3 - off 1200 Baud*
4 - on 1200 Baud*
5 - Not Used
6 - off no parity
7 - off Pin 20 & pin 11 act as busy line
• WEIgH-TRONIX Printer
- IMP-24 Model 2600
SW1 - off 1200 Baud*
2 - on 1200 Baud*
Model 1220
- Configure Menu
Baud= 1200
Data Bits = 8
Stop Bits = 1
Hshake = Busy-Line
Cols = 32
Invert = No
Font = 5 x 8
Mag = None
- Custom Menu
Auto Seq = No
Zero = 0
Pound sign = #
_(Underscore)
Busy invert = no
Online/offline = yes
Ext Ch Set = no
Print ready = yes
Set Clock = Not Used
Reset Seq = Not Used
152
• SEIKO
DipSW1-1 = off Input-Serial
1-2 = on Printing speed high
1-3 = on Auto loading - on
1-4 = off Auto LF - off
1-5 = on Setting Command - Enable
1-6 = off Printing density - 100%
1-7 = on Printing density - 100%
1-8 = on Printing, density - 100%
DipSW 2-1 = on Printing Columns - 40
2-2 = on User Font Back-up - on
2-3 = on Character Select - normal
2-4 = off Zero - slash
2-5 = on International character set - American
2-6 = on International character set - American
2-7 = on International character set - American
2-8 = off International character set - American
DipSW 3-1 = on Data length - 8 bits
3-2 = on Parity Setting - no
3-3 = on Parity condition - odd
3-4 = on Busy control - H/W busy
3-5 = on Baud rate select - 1200*
3-6 = off Baud rate select - 1200*
3-7 = on Baud rate select - 1200*
3-8 = off Baud rate select - 1200*
* Settings shown for 1200 Baud. Other Baud rates can
be selected. Refer to Printer manufacturer's manual
supplied with Printer.

ConTrol CenTer SeTup

Chiller id
Access Level Required: OPERATOR
Using the COMMS Screen, assign an Identification
number to the chiller. This number will appear at the
top of each report.
FORM 160.67-O1
ISSUE DATE: 4/1/2015
JOHNSON CONTROLS