Sega WaveRunner Owner's Manual page 85

5 Moving the Volume Bracket causes Adjust Gear mesh to be disengaged.
6
Adjust gear mesh and tighten the 2 Nuts.
Grip the Throttle Lever and check to ensure that the V. R. value variations are within the
7
rotatable range of the Volume Shaft.
8
After finishing adjustments, be sure to perform Throttle Volume setting on the Volume Setting
screen in the Test mode (see 9 - 3e).
REPLACING THE THROTTLE VOLUME
Turn the power off.
1
2
Perform the above adjustment procedure
3
Disconnect the connector connected to the Throttle Volume. (PHOTO 12. 1 d)
4
Take out the 2 Nuts which secure the Volume Bracket, and remove the Volume Bracket with
the Volume as is attached.
5
Remove the Volume Gear from the Volume Shaft, and replace the Volume by removing from
the Bracket.
6
After the replacement, perform Volume Setting in the Test mode (see 9 - 3e).
www.seuservice.com
1
THROTTLE VOLUME
220-5373,5484
CONNECTOR (1)
BLACK 3P
76
~ 3 .
PHOTO 12. 1 d