Error Message - Sega WaveRunner Owner's Manual

17 - 2 ERROR MESSAGE

This work should be performed by the Location's Maintenance Man or
Serviceman. Performing work by non-technical personnel can cause
accidents.
Should any errors other than listed by this manual or by NAOMI Service
Manual occur, contact where the product was purchased from or an office
described in this manual. Failing to comply with this instruction can cause
accidents.
This product displays the error on the screen if the faulty is detected. If an error is displayed, be
sure to take action against it according to the appropriate cause and countermeasures listed
below.
It may be displayed the error other than listed by this manual or by NAOMI Service Manual. In
that case, contact where the product was purchased from or an office described in this manual
without operating it selfishly.
DISPLAY
CAUSE
COUNTERMEASURES
DISPLAY
CAUSE
COUNTERMEASURES
DISPLAY
CAUSE
COUNTERMEASURES
DISPLAY
CAUSE
COUNTERMEASURES
DISPLAY
CAUSE
COUNTERMEASURES
DISPLAY
CAUSE
COUNTERMEASURES
NETWORK ERROR: NO MASTER SITE
No MASTER setting in Communication Mode.
Perform the Communication Mode setting in the Game Assign-
ments. Set one of the machines to MASTER and all others to
SLAVE. (9-3 d) (20-3)
NETWORK ERROR: DUPLICATE MASTER SITE
MASTER setting is duplicated in Communication Mode.
Perform the Communication Mode setting in the Game Assign-
ments. Set one of the machines to MASTER and all others to
SLAVE.
NETWORK ERROR: NO SLAVE SITE
No SLAVE setting in Communication Mode.
Perform the Communication Mode setting in the Game Assign-
ments. Set one of the machines to MASTER and all others to
SLAVE. (9-3 d) (20-3)
NETWORK ERROR: TOO MANY NODES SITE
Too many machines are connected.
Up to 4 machines can be connected to allow to enjoy communica-
tion play.
NETWORK ERROR: DUPLICATE CABINET ID
The number of Cabinet ID is duplicated in Communication Mode.
Change the number of Cabinet ID for every seat in the Game As-
signments. (9-3 d) (20-3)
DRIVE BD ERROR: E2H
The Ride is not centering with the right value.
Ensure that the Ride is slanted or the connector of ASSY Wire
Tube is connected securely. (Section 6)
101
www.seuservice.com