Sega WaveRunner Owner's Manual page 50

INPUT TEST
When INPUT TEST is selected, the following screen appears on the monitor. The screen
allows the status of each SW and the value of each V.R. of the cabinet to be viewed.
On this screen, periodically check the status of each switch & V.R.
INPUT TEST
HANDLE BAR
ROLL
THROTTLE LEVER
PITCH
START
VIEW
SAFETY SENSOR
SERVICE
TEST
PRESS TEST AND SERVICE BUTTON TO EXIT
FIG. 9. 3 b a INPUT TEST Screen
LIGHT EMITTER
LIGHT RECEIVER
LIGHT EMITTER
LIGHT RECEIVER
The standard values for adjusting each V. R. are as follows:
In this product, the item of VOLUME SETTING allows V. R. values except for PITCH to be
set.
HANDLE BAR:
ROLL:
THROTTLE LEVER: e 0 H + 9 (lever released)
PITCH:
0H
0H
FFH
0H
OFF
OFF
OFF
OFF
OFF
LIGHT EMITTER
LIGHT RECEIVER
8 0 H + 9 (centering position)
8 0 H + 9 (centering position)
Over 7 0 H (When the Ride is lowered) ~ Under e 0 H (When the Ride is
raised)
41
• By pressing each switch, if the display on
the right-hand side of the name of each
switch changes to ON from OFF, the SW
and the wiring connections are satisfactory.
• When checking the SAFETY SENSOR, be
sure to intercept the 3 Sensors on the step.
• Simultaneously pressing the Service button
and the Test button returns the Game Test
Menu screen.
FIG. 9. 5 b SAFETY SENSOR
www.seuservice.com