Sega WaveRunner Owner's Manual page 102

POINT CONVERGENCE ADJUSTMENT
In the POINT CONVERGENCE adjustment, each of red, green and blue images is partially
moved for color matching. The adjustment may be necessary when the Game Board is replaced or
changed, or screen size is changed. Be sure to perform automatic color matching before starting
the adjustment.
TEST MODE WRITING
R G B
PIC-ADJ
POSITION
ADJUST
SELECT
Note 1 When the MODE button is repeatedly
pressed, the adjustment modes will
circulate as follows:
STATIC ADJUSTMENT MODE
LINE ADJUSTMENT MODE
POINT ADJUSTMENT MODE
Note 2 When either of the COLOR SELECT
buttons (R, B) is pressed, if the desired
color to be adjusted disappears, press
that particular button again.
Note 3 By repeatedly pressing the SELECT
button, only the Projector's TEST
pattern screen and the screen
superimposing the Game Board Test
pattern can be alternately displayed.
P
SET
MARKER
DO NOT
PRESS.
RESET
1
Keep pressing the TEST button for
approximately 3 seconds.
The screen changes to ADJUST
ADJUST MODE
mode from the Game mode and
displays the green test pattern.
2
Press the MODE button twice to have the POINT
ADJUSTMENT mode.
The crosshatch test pattern appears
ADJUST MODE
and the MARKER indicating the
adjustment point is displayed.
3 Using either R or B button, select the desired color
to be adjusted.
Note 2
green color can also be selected.
The selected color is displayed by
ADJUST MODE
superimposing on green. The
MARKER will be in the color
selected.
4
By using the
move the MARKER to the position to be adjusted.
The MARKER moves in the
ADJUST MODE
direction of the button's arrow.
However, the movable point is
predetermined.
5
Make adjustment by using the
ADJUST buttons.
Although the direct vicinity of the
MARKER's center moves most
conspicuously, make adjustment
by paying attention to the periph-
ery area also. Shown left is the
magnified MARKER periphery.
6
Press the SELECT button as necessary to
superimpose Game Board images.
If the test pattern is not displayed in
ADJUST MODE
the periphery of the screen, adjust-
ments can be made by pressing the
SELECT button to superimpose the
test pattern and the Game Board's
CRT test screen.
7
Press the WRITING button (for storing and finish).
WRITING is displayed and the
ADJUST MODE
adjustment data is stored. After the
data is stored, the Game Board
screen returns.
WRITING
93
Note 1
By using the G button, the
ADJUST buttons,
Note 3
www.seuservice.com