Account/Network Settings - Grandstream Networks GXV3240 Administration Manual

SIP Server
SIP User ID
SIP Authentication ID
SIP Authentication
Password
Voice Mail Access
Number
Name
Show Account Name
Only
Tel URI

Account/Network Settings

Outbound Proxy
Secondary Outbound
Proxy
Specifies the URL or IP address, and port of the SIP server. This should
be provided by VoIP service providers (ITSP).
Configures the user account information, provided by your VoIP service
provider (ITSP). It's usually in the form of digits similar to phone number or
actually a phone number.
Configures the SIP service subscriber's Authenticate ID used for
authentication. It can be identical to or different from the SIP User ID.
Configures the account password required for the phone to authenticate
with the ITSP (SIP) server before the account can be registered. After
saving, it will appear as hidden for security purpose.
Sets if the phone system allows users to access the voice messages by
pressing the MESSAGE key on the phone. This ID is usually the VM portal
access number. For example, in UCM6100 IPPBX, *97 could be used.
Specifies the SIP server subscriber's name (optional) that will be used for
Caller ID display. The configured content will be included in the From,
Contact and P-Preferred-Identity headers of SIP INVITE message.
Enables to display the account name, if it is checked, the user ID will be
hidden and the account name will be displayed only.
Indicates E.164 number in "From" header by adding "User=Phone"
parameter or using "Tel:" in SIP packets, if the phone has an assigned
PSTN Number.
•
Disabled: Will use "SIP User ID" information in the Request-Line and
"From" header.
•
User=Phone: "User=Phone" parameter will be attached to the
Request-Line and "From" header in the SIP request to indicate the
E.164 number. If set to "Enable".
•
Enabled: "Tel:" will be used instead of "sip:" in the SIP request.
Please consult your carrier before changing this parameter.
Configures the IP address or the domain name of the primary outbound
proxy, media gateway, or session border controller. It's used by the phone
for firewall or NAT penetration in different network environments. If a
symmetric NAT is detected, STUN will not work and only an outbound
proxy can provide a solution.
Sets the IP address or the domain name of the secondary outbound proxy,
media gateway, or session border controller. The phone system will try to
connect the secondary outbound proxy only if the primary outbound proxy
fails.
GXV3240 Administration Guide
Version 1.0.3.207
P a g e |
49