Account Page Definitions; Account/General Settings; Account/Network Settings - Grandstream Networks GXV3275 Administration Manual

Account Page Definitions

GXV3275 has six lines that can be configured to accommodate 6 independent SIP accounts. Each SIP
account has an individual configuration page.

Account/General Settings

Account Active
Account Name
SIP Server
SIP User ID
SIP Authentication ID
SIP Authentication
Password
Voice Mail Access Number
Name
Show Account Name Only
Tel URI

Account/Network Settings

Outbound Proxy
Indicates whether the account is active. The default value for the IPVideoTalk
account (Account 6) is "Yes" and the default value for the first five accounts is "No".
Configures the name associated with each account to be displayed on the LCD.
Specifies the URL or IP address, and port of the SIP server. This should be
provided by VoIP service providers (ITSP).
Configures user account information provided by your VoIP service provider (ITSP).
It's usually in the form of digits similar to phone number or actually a phone number.
Configures the SIP service subscriber's Authenticate ID used for authentication. It
can be identical to or different from the SIP User ID.
Configures the account password required for the phone to authenticate with the
ITSP (SIP) server before the account can be registered. After saving, it will appear
as hidden for security purpose.
Sets if the phone system allows users to access the voice messages by pressing
the MESSAGE key on the phone. This ID is usually the VM portal access number.
For example, in UCM6100 IPPBX, *97 could be used.
Specifies the SIP server subscriber's name (optional) that will be used for Caller ID
display. The configured content will be included in the From, Contact and P-
Preferred-Identity headers of SIP INVITE message.
Enables to display the account name; if it is checked, the user ID will be hidden and
the account name will be displayed only.
Indicates E.164 number in "From" header by adding "User=Phone" parameter or
using "Tel:" in SIP packets, if the phone has an assigned PSTN Number.

Disabled: Will use "SIP User ID" information in the Request-Line and "From"
header.

User=Phone: "User=Phone" parameter will be attached to the Request-Line
and "From" header in the SIP request to indicate the E.164 number. If set to
"Enable".

Enabled: "Tel:" will be used instead of "sip:" in the SIP request.
Please consult your carrier before changing this parameter. Default is "Disabled".
Configures the IP address or the domain name of the primary outbound proxy,
media gateway or session border controller. It's used by the phone for firewall or
NAT penetration in different network environments. If a symmetric NAT is detected,
GXV3275 Administration Guide
P a g e | 43