Grandstream Networks GXV3240 Administration Manual page 63

Configure Door System
Feature Key
Synchronization
Enable BroadSoft Call
Park
Enable Call Features
No Key Entry Timeout
(s)
ZTE IMS, Mobotix, ZTE NGN, Huawei IMS, NEC, WorldStone, or Baudisch
Door System, depending on the server type. The default setting is
"Standard".
Note: When set "Special Feature" to "Baudisch Door System", groups of
door system URL and User ID will show up for users. Up to 100 entries can
be configured.
•
Baudisch Door System URL: This is used to input IP address or URL
of the system to make sure the account could identify the call from door
system (up to 100 entries).
Users can set HTTP authentication credentials on the URL for Door
Systems that require authentication to send the HTTP stream. The URL
format will be the following:
http://username:password@192.168.1.150/goform/stream?cmd=get&c
hannel=4
•
Baudisch Door System SIP User ID: This is used to configure the
User ID of door system. Once configured, only the call from this User
ID would use door system while other calls use standard mode.
Specifies which calls from specific ID will be using door system; others will
use standard mode. Click on "Configure" to access the configuration page,
fill in IP address or URL and user ID.
Notes:
•
Users can have DTMF programmable key displayed in call screen
under Baudisch door system feature.
•
Users can also have the call menu after receiving an audio call
under Baudisch door system feature.
Synchronizes the BroadSoft standard call feature. If it is enabled, the phone
will send SIP SUBSCRIBE message to the server and receive SIP NOTIFY
message from the server to synchronize the DND, Call Forwarding and Call
Center features. The default setting is "Disable".
Configures whether to send SUBSRCIRBE message to BroadSoft server to
obtain Call Park notifications. The default setting is "No".
Configures the local start command feature. If it is set to "Yes", the feature
will be enabled to recognize the local star code command. Otherwise, it will
be disabled. The default setting is "No".
Determines the expiration timer (in seconds) for no key entry. The dialed
digit will be send out if no other digits entered within the set period. The
default value is 4 seconds. The valid range is from 1 to 30, and when it is
set to 0, this setting is disabled (Example: after user enters digits, device
would not dial out automatically). This feature does not work if the dialer
page is entered via the Account Widget on the phone.
GXV3240 Administration Guide
Version 1.0.3.207
P a g e |
63