Advanced Settings/Multicast Paging - Grandstream Networks GXV3240 Administration Manual

Advanced Settings/Multicast Paging

Allow Multicast in DND
Mode
Paging Barge
Paging Priority Active
Multicast Paging Codec
Enable Multicast Paging
Video
Multicast Paging Video
Codec
Multicast Paging Image
Size
Multicast Paging Video
Bit Rate
Multicast Paging Video
Frame Rate
Multicast Paging H.264
Profile Type
Multicast Paging H.264
Payload Type
Multicast Listening
Address
When enabled the device can receive multicast paging if DND is activated.
Sets the threshold of paging calls. If the paging call's priority is higher than
the threshold, the existing call will be hold and the paging call will be
answered. Otherwise, the existing call does not be affected. If it is set to
Disable, any paging call will not be answered. Default setting is "Disable".
Determines if a new paging call whose priority is higher than the existing
paging call will be answered. If it is checked, this feature will be enabled.
The default setting is disabled.
Selects the codec type for the multicast paging call. This list includes
PCMU, PCMA, G726-32, G722, and G729A/B.
Enables the video feature to establish a multicast paging call. The default
setting is disabled.
Sets the video codec for the multicast paging call. Default setting is
"H.264".
Sets the video image size for the multicast paging call. This list includes
720P, 4CIF, VGA, CIF, QVGA, and QCIF.
Determines the video bit rate for the multicast paging call. The default
setting is "256 kbps".
Configures the video frame rate for the multicast paging call. This list
includes "15 frames/second", "25 frames/second", "30 frames/second", and
"Variable frames rate".
Specifies the H.264 codec profile type for the multicast paging call. This list
includes "Baseline Profile", "Main Profile", and "High Profile".
Note: Lower profile is easier to decode, while higher profile has higher
compress rate. Usually, use Baseline profile for low CPU Performance
device, and choose high profile for video conference.
Determines the H.264 codec payload type for the multicast paging call. The
default setting is "99".
Configures the IP address and port number for monitoring multicast paging
call. When the initiator initiates a call, answer the call and display listening
address and tag of the monitoring target. This feature supports Video
Multicast, when the initiator initiates Video Multicast, it will automatically
add the number 2 on the port of the listening address. Reboot the phone
to make changes take effect. The valid IP address ranges from 224.0.0.0
to 239.255.255.255. Users may also fill the label for each listening address
corresponding to the priority.
GXV3240 Administration Guide
Version 1.0.3.207
P a g e |
74