Kenwood ProTalk TK-3601D User Manual page 19

To change the operating frequency of a channel:
With the transceiver power OFF, press and hold the Menu button while turning
1
the transceiver power ON.
Press the
2
• Press the
• Press the
Press the Menu button then press the
3
table number or OFF (skip channel) for the channel.
Press the Menu button to exit the selection, then press the PTT switch or the
4
Side button to exit the Front Panel Programming mode.
Note:
◆ You can mix analogue and digital table numbers in the same zone.
◆ You cannot set all channels (Zone 1 - Channel 1 to Zone 3 - Channel 16) to OFF.
◆ When Channel set for Second Channel is set to OFF, Second Channel function will also
be OFF {p.40}.
or button to select your desired zone and channel.
button to change as follows.
button to change in reverse order.
or button to select the frequency
19