Setting Other Parameters - Denso HC36IITK-A Operation Manual

6.5 Setting Other Parameters

Trigger switch control
You may choose the trigger switch control mode from the following
five:
(1) Auto-off mode
Pressing the trigger switch makes the scanner ready to scan for
five seconds. If the code reading is completed successfully or five
seconds pass, then the scanner will automatically return to the
standby mode.
(2) Momentary switching mode
Only while you hold down the trigger switch, the scanner can read
a bar code. Releasing the trigger switch will return the scanner to
the standby mode.
(3) Alternate switching mode
Pressing the trigger switch toggles between the ready-to-scan
mode and standby mode.
(4) Repeat mode
Turning on the scanner immediately makes it ready to scan and
keeps it in the ready-to-scan mode. Even if the code reading is
completed, you may read the same code repeatedly by pressing
the trigger switch by the required number of times, provided that
the reading window remains in contact with that bar code and the
indicator LED lights in green.
(5) Continuous reading mode
Turning on the scanner immediately makes it ready to scan and
keeps it in the ready-to-scan mode. No trigger switch operation is
required. Note: If you turn on the scanner with the reading window
applied to a bar code, the scanner cannot read the bar code. To
read the code, pull the reading window away from the bar code and
then bring it back to the code again.
"Auto-off mode" (Default)
"Alternate switching mode"
"Continuous reading mode"
"Momentary switching mode"
"Repeat mode"
27