Wireless Communication Parameters - Denso BHT-400-CE Reference Manual

5.2. Wireless Communication Parameters

Make the following system settings in order to establish the wireless communication pathway.
• ESSID (Extended Service Set ID)
Can be set from the ZeroConfig menu or in the user program.
• POWER
Can be set from the System menu or in the user program.
When making the settings in the System menu, please refer to the "BHT-400B-CE/400BW-CE User's Manual" for
further details.
When no settings are made at the user program, the system settings set at the ZeroConfig menu or in the System
menu are used as is.
ESSID
Specify a character string for the ID used over the wireless network. Set the same ID as the SSIS for the
access point used for communication. Communication will not be possible if set incorrectly.
[Ex.] "BHT400" is set for the ESSID.
MyProfile. SSID = "BHT400"
POWER
It is possible to set the power mode for the BHT wireless module. The following two power modes are
available. The default is EN_POWERSAVE.CAM.
Power Mode
CAM(Continuously Access Mode) Max. power consumption
PSP(Power Saving Polling)
[Ex.] Set the power mode to "Consumes much power".
RF.Settings.PowerSave = RF.Settings.EN_POWERSAVE.CAM
Power Consumption Status
Min. power consumption
- 9 -