Omron CJ Series Connection Manual page 28

7.3.3. Creating the I/O Table and Setting the IP Address
Create the I/O table and set the IP address of PLC.
1
If the operating mode of PLC is
Run Mode or Monitor Mode,
change it to Program Mode by
following the steps below.
(1)Select Operating Mode -
Program from the PLC
Menu in CX-Programmer.
(2)The dialog box on the right is
displayed. Confirm that there
is no problem, and click Yes.
*Refer to Additional Information
on the previous page for the
settings concerning the dialog
display.
(3)Check that Stop/Program
Mode is displayed on the
right of the PLC model in the
Project Workspace of
CX-Programmer.
2
Select Edit - I/O Table and Unit
Setup from the PLC Menu in
CX-Programmer.
The PLC IO Table Window is
displayed.
7．EtherNet/IP Connection Procedure
(Project Workspace)
25