Omron CJ Series Connection Manual page 18

7.2.2. Parameter Settings
Set the parameters for Slave Terminal.
The parameters are set using Sysmac Studio.
Install Sysmac Studio and the USB driver on Personal computer beforehand.
Additional Information
For information on how to install Sysmac Studio and the USB driver, refer to A-1 Driver
Installation for Direct USB Cable Connection in Appendices of the Sysmac Studio Version 1
Operation Manual (Cat. No. W504).
1
Turn ON Unit power supply for
Slave Terminal.
2
Start Sysmac Studio.
*If the User Account Control
Dialog Box is displayed at
start, make a selection to start
Sysmac Studio.
3
Sysmac Studio starts.
Click New Project.
4
The Project Properties Dialog
Box is displayed.
*In this document, New Project
is used as the project name.
Select Slave Terminal from the
pull-down list of Category.
7．EtherNet/IP Connection Procedure
15