Pfaff 3588-05/020 Instruction Manual page 147

300 301 NIS (carriage start) [°], see Chap. 13.10.03
302 Take-up lever tdc [°]
303 Thread trimming on [° ]
Point at which impulse for thread trimming is given to
thread trimming valve is changed (° = degrees after
tdc needle bar).
305 Thread trimming off [° ]
306 Open thread tension
400
401 Time for label clamp closed [0.01 s]
500
501 Reduced speed
502 Cutting speed (positioning speed)
503 Speed for slow start stitches
504 Slow start stitches
Number of stitches, which are to be sewn at reduced
speed when sewing starts, is changed
505 Delay stitches zig-zag on
This parameter is used to enter the number of stit-
ches after which the "zig-zag on" command is given la-
ter, see Chapter 13.10.04 Delay zig-zag on/off
506 Delay stitches zig-zag off
This parameter is used to enter the number of stit-
ches after which the "zig-zag off" command is given la-
ter, see Chapter 13.10.04 Delay zig-zag on/off
600
601 Direction of slow rolling stacker
0 = backwards: 1 = forwards
602 Slow rolling time stacker [0.01 s]
This parameter is used to enter the time for the
slow rolling motion of the stacker roller, see Chapter
13.10.05 Stacker rolling time
603 Quick rolling time stacker [0.01 s]
This parameter is used to enter the time for the
quick rolling motion of the stacker roller, see Chapter
13.10.05 Stacker rolling time
Adjustment
80 – 150 110
70 – 90 75
160 – 360 200
Parameter 345
303 / 302
5 - 20 15
10 – 256 20
200 – 4000 3600
50 - 250 200
200 - 700 700
0 – 99 2
0 - 99 3
0 - 99 3
0 - 1 1
0 - 999 50
0 - 999 35
147