Mira Mode Maxim Installation And User Manual page 17

8
Connect the elbow (supplied) onto the
end of the brass pipe. Push all parts
together fully and lock elbow onto pipe
using clip supplied
10
Ensure pipework is thoroughly flushed through before fitting the deluge head.
Screw the fixed shower head onto the brass pipe outlet.
Note: Use two suitably sized wrenches to tighten (approximately 1/4 turn).
Slide the chrome shroud down to conceal the brass pipe. Turn on the shower
control and check for leaks.
The CloudCore™ spray plate can be removed for cleaning or changed to the
RainCore™ spray plate which is more suitable for hard water areas. Refer to
'Cleaning and Maintenance'.
32
9
Connect the shower control outlet
pipework to the elbow. Fit an isolating
valve between the shower control
outlet and the elbow to enable easy
maintenance. (Pipe and isolating valve
not supplied). Lock pipe to elbow using
clip supplied. Follow manufacturers
guidelines for fitting alternative push-
fit connections and flexible pipework.
Shower Arm
Note! Make sure that the
Flow Regulator
flow regulator is fitted in
the correct orientation.
Deluge Head
Installation: Rear Fed Shower Fittings
Suitable for solid, dry-lined, stud partition, shower cubicle or laminated panel walls. Plan
installation location of the handshower and deluge showerhead before installing fittings kit.
Note: Make sure that the deluge head is not installed over the handshower.
Fix at convenient height for all users. Position so that water sprays down the centre of the
bath, or away from the opening of a shower cubicle. Water should spray away from the
Controller when the Handshower is held on the slide bar.
1
The right angle connector must be fitted to a waterproof, flat and even wall surface. The
screws and wall plugs supplied are suitable for most solid wall installations. Alternative
fixing screws for panel structures are not supplied. Use both fixing points to secure the
right angle connector, be sure to use fixings appropriate for the chosen wall structure.
1300 mm Minimum to
achieve a comfortable
shower height for all users
Using a suitable pipe cutter, trim the pipework back to the required depth from the
finished wall surface. Remove all burrs and sharp edges.
31 - 34 mm
90°
33