Mira Mode Maxim Installation And User Manual page 12

Installation: Controller
1
Position the installation template (supplied) at the position on the wall where you
intend to install the Controller.
Make sure that the template is level and mark the positions of the fixing holes on the wall.
2
For solid walls drill the fixing holes for the backplate with a 6mm drill and insert the
wall plugs (supplied). For other types of wall structure alternative fixings may be
required (not supplied).
Note: The Controller must be installed on a flat and even wall surface avoiding
any grout lines.
Using a suitable hole saw, drill the hole for the Controller cable as per the dimensions
given. Route the cable from the digital valve through the wall.
6.0 mm
29 - 30 mm
22
3
Fit the backplate to the wall in the orientation shown using the fixing screws (supplied).
Tighten by hand, do not over tighten.
4
Connect the cable on the back of the Controller to the cable that comes from the valve.
5
Locate the top of the Controller in the backplate and press down on the bottom button
as you install in position.
DO NOT Drill
into buried pipes
DO NOT Drill
into buried cables
23