Connecting To A Token Ring Interface; Connecting To An Stp Token Ring Interface - Bay Networks BayStack ARN Routers none Installation And Operating Manual

Connecting to a Token Ring Interface

You can connect a token ring cable to any ARN base module or expansion module
that contains a token ring interface option. Each of these interface options offers
two token ring interface types -- an STP interface or a UTP interface.
Note: You can use only one token ring interface on an ARN base or expansion
module at any time. For example, you can connect to either the STP interface
or the UTP interface on a base module, but you cannot use both interfaces at
the same time.

Connecting to an STP Token Ring Interface

To connect a token ring STP cable to the base module or expansion module token
ring interface:
1.
U
D B1
1
ISDN BRI
DD B2
withNT1
COM
2
RLSD
Serial
To
Token Ring
network
Figure 1-7. Connecting a Token Ring STP Cable
2.
114200 Rev. A
Attach the 9-pin D-SUB plug to the token ring STP interface
Expansion module STP interface
Base module STP interface
UTP
RCVR
STP
NSRT
WFLT
Token Ring 2
RCVR
STP
NSRT
WFLT
Token Ring 1
Token Ring STP cables
Secure the token ring cable using the capture screws.
Installing the BayStack Advanced Remote Node
RLSD3 COM3
RLSD4
RLSD5
Run Pwr Base Expansion
Boot RPS Adapter1 DCM
Fail Fan Adapter2 PCMCIA
(Figure 1-7).
COM4 COM5
Serial
BayStack Advanced Remote Node
ARN0068A
1-13