Bay Networks BayStack ARN Routers none Installation And Operating Manual page 72

Installing and Operating BayStack ARN Routers
The
directed netboot, the location must includes the following information:
•
•
•
Write the commands in
Table 2-4.
bconfig image
bconfig config
You can use the ARN monitor, Technician Interface, or Site Manager to perform
directed netboot. However, this guide assumes that you are using either the ARN
monitor or the Technician Interface. To manage the ARN from a remote site, refer
to Configuring Remote Access.
To use the directed netboot feature:
1.
2.
2-12
commands let you specify the location of a startup file. To use
bconfig
The source of the image and configuration files (local or network)
The address of the TFTP server
The full directory path description locating the files on the TFTP server
Table 2-4
Your bconfig Commands
Enter the command (refer to
ifconfig
prompt and press the Return key.
The following is a sample command:
ifconfig com1 9.0.0.2 255.0.0.0 9.0.0.3
Refer to Appendix A for more information about the
Enter the bconfig commands (refer to
prompt and press the Return key.
You must enter one bconfig
image, and another to specify the location of the configuration file.
The following are sample commands:
bconfig image network 192.32.5.8 /usr/arnstartup/krnl_arn.exe
bconfig config network 192.32.5.8 /usr/arnstartup/config
Refer to Appendix A for more information about the
for your reference.
Table 2-3) at the command line
Table 2-4) at the command line
command to specify the location of the software
ifconfig command.
bconfig command.
114200 Rev. A