Bay Networks BayStack ARN Routers none Installation And Operating Manual page 70

Installing and Operating BayStack ARN Routers
3.
Note: If the ARN cannot find a software image or configuration file using the
netboot procedure, it attempts to local boot once. If both attempts fail, the
ARN continues to netboot and local boot until it boots successfully. If the
ARN remains in this loop, refer to "Interrupting the Boot Process" earlier in
this chapter.
4.
Contact your network administrator to verify that the ARN is now connected to
the network. Your network administrator can refer to Configuring Remote Access
to troubleshoot any problems.
Contact your local Bay Networks Technical Response Center if you need
additional assistance.
After connecting the ARN to the network, you can replace the local console with a
modem connection to enable remote dial-in access.
2-10
If getcfg displays the correct information, continue to the next step.
Otherwise, reenter the correct
administrator if you need assistance.
Enter the following command and press the Return key to boot the ARN:
boot
Your console displays messages indicating the progress of the netboot
procedure.
Ensure that the ARN boots correctly.
When the ARN boots, its LEDs flash in a particular order. See Chapter 3 for
information on checking the ARN front-panel LEDs to ensure that the
installation was successful and that the router is operating properly.
command. Contact your network
ifconfig
114200 Rev. A