Bay Networks BayStack ARN Routers none Installation And Operating Manual page 73

3.
Figure 2-2.
4.
114200 Rev. A
Type the following command and press the Return key to verify the
configuration you specified in Step 3:
getcfg
The command shows the location of the boot image and the network
getcfg
configuration file, the interface configuration that you specified using the
command, as well as the TFTP server information and file paths that
ifconfig
you specified using the
Verify the interface configuration, as shown in
$ getcfg
Boot Options
boot image = network
boot config = network
host IP address = 192.32.5.8
image pathname =
"/usr/arnstartup/krnl_arn.exe"
config pathname =
"/usr/arnstartup/config"
Netboot Parameters:
MAU1...None
XCVR2..None
COM1...IP=9.0.0.2, Mask=255.0.0.0, Next Hop=9.0.0.3
COM2...EZ-Install (disabled)
COM3...EZ-Install (disabled)
COM4...EZ-Install (disabled)
COM5...EZ-Install (disabled)
Verifying Directed Netboot Configuration
If displays the correct information, continue to Step 4. Otherwise,
getcfg
reenter the correct
ifconfig
administrator if you need assistance.
Type the following command and press the Return key to boot the ARN:
boot
commands.
bconfig
and commands. Contact your network
bconfig
Starting the ARN
Figure 2-2.
ARN0080A
2-13