Table of Contents
Advertisement
Table A-1.
Setting
-fr
-annexd
-annexa
-lmi
-int_clk
<interface>
<IP address>
<subnet mask>
<next hop
address>
114200 Rev. A
Configuring the ARN for Netboot and Directed Netboot
ifconfig Command Settings for a COM Interface
Description
Frame Relay Settings
Configures the router COM interface as a Frame Relay connection.
With this setting, use one of the following options to specify a DLCMI
setting: -annexd, -annexa, or -lmi.
When one of these options is used with the -fr setting, it specifies a
DLCMI setting. Use the same setting as the network to which the
router's Frame Relay interface is connected. The default setting for
Frame Relay is -annexd.
Internal Clocking Setting
Sets the serial interface to internal clocking at 1.25 MB/s. If you do not
specify this setting, the router defaults to external clocking.
IP Connector Setting
Specifies the IP connector you are configuring. Use the format
com< port # >.
IP Address Settings
Specifies the IP address of the interface you set with <interface> .
Provide this address in dotted decimal notation.
Specifies the IP subnet mask of the interface you set with <interface> .
Provide this address in dotted decimal notation.
Specifies the IP address of the next-hop router. Provide this address
in dotted decimal notation. Specify this address only if there are
intermediate routers between the router and the BootP server.
(continued)
A-3
Advertisement
Table of Contents
