Table of Contents
Advertisement
Installing and Operating BayStack ARN Routers
Note: If the ARN cannot find a software image or configuration file using the
directed netboot procedure, it attempts to netboot once. If the netboot
procedure fails, the ARN tries to local boot once. If all three boot attempts fail,
the ARN continues to try directed netboot, netboot, and local boot until it
boots successfully. If the ARN remains in this loop, refer to "Interrupting the
Boot Process" earlier in this chapter.
5.
Contact your network administrator to verify that the ARN is now connected to
the network. Your network administrator can refer to Configuring Remote Access
to troubleshoot any problems.
Contact your local Bay Networks Technical Response Center if you need
additional assistance.
After connecting the ARN to the network, you can replace the console connection
with a modem connection to enable remote dial-in access.
2-14
Ensure that the ARN boots correctly.
When the ARN boots, its LEDs flash in a particular order. See Chapter 3 for
information on checking the ARN front-panel LEDs to ensure that the
installation was successful and that the router is operating properly.
114200 Rev. A
Advertisement
Table of Contents
