Bay Networks BayStack ARN Routers none Installation And Operating Manual page 116

Installing and Operating BayStack ARN Routers
PPP Standard Worksheet
Requested Information
Enable use of the Remote Peer
router's LQR Timer? (y/n) [y]:
(For LQR Protocol only)
Number of seconds (1-120) [3]:
(For LQR Protocol only)
Enter [inbound] success rate
percentage (1-100) [90]:
Enter [outbound] success rate
percentage (1-100) [90]:
B-14
(continued)
Options
y(es)
n(o)
Note: If the LQR timer is
enabled, the remote peer router
maintains its own LQR timer for
this interface. When the LQR
timer is disabled, the AN is
responsible for maintaining the
timer for this interface.
Enter the maximum number of
seconds between the
transmission of LQR packets.
Enter the minimal acceptable
success rate (percentage) of
packets transmitted by the peer
router and received on this
interface over the last five LQR
reporting periods.
Enter the minimal acceptable
success rate (percentage) of
packets transmitted by this
interface and received by the
peer router over the last five LQR
reporting periods.
Your Response
114200 Rev. A