Grizzly G0767Z Owner's Manual page 37

Operation
Symptom Possible Cause
Abrasive belt stops 1. Abrasive belt not properly tensioned.
rotating under load.
2. Feed rate too fast.
Abrasive belt tracks 1. Abrasive belt tracking not properly set.
to one side under
2. Abrasive belt not properly tensioned.
load.
Abrasive belt 1. Tube not moved across face of abrasive
excessively worn in
belt during operation.
one spot.
Tube has burn 1. Abrasive belt worn/not correct grit for task.
marks at notch.
2. Feed rate too fast.
Notch not centered 1. Profile roller not even with center of tube.
on tube.
Model G0767Z (Mfd. Since 11/17)
Possible Solution
1. Properly tension abrasive belt (Page 24).
2. Reduce feed rate.
1. Properly set abrasive belt tracking (Page 25).
2. Properly tension abrasive belt (Page 24).
1. Use traverse crank to evenly move tube across face
of abrasive belt during operation (Page 29).
1. Use new abrasive belt with appropriate grit.
2. Reduce feed rate.
1. Adjust profile roller height (Page 36).
-35-