Grizzly G0767Z Owner's Manual page 30

6. Loosen vise cap screws (see Figure 30).
Cap
Screws
Angle Scale
Figure 30. Vise angle controls.
7.
Using angle scale, rotate vise to desired
angle of notch (from 90° to 30° in relation to
front profile roller), then retighten both cap
screws.
8. Use crank handle (see Figure 31) to adjust
space between clamp plate and jaws to
accept tube.
Jaws
Clamp
Plate
Figure 31. Vise clamping controls.
-28-
Crank
Handle
Clamp Lever
When mounting tubes longer than 3', have
another person support end of tube. This
will reduce risk of tube unexpectedly coming
loose in vise during operation and causing
impact injuries or equipment damage.
In next step, make sure tube end you
plan to notch is protruding far enough
out of vise that vise will not contact belt
during operation. Otherwise, material and
equipment damage may occur.
9. Insert tube between jaws and clamp plate
(see Figure 32), making sure tube extends
far enough that notching operation can be
performed without vise contacting belt.
Spark
Shield
Jaws
Clamp
Plate
Vise
Figure 32. Tube inserted in vise.
10. Loosen clamp lever (see Figure 31), then
use crank handle to position clamp plate
within ⁄ " of tube.
1
16
11. Tighten clamp lever to lock tube in place.
Note: If it is difficult to secure tube with clamp
lever, use crank handle to slightly increase
distance between clamp plate and tube, then
try again.
Model G0767Z (Mfd. Since 11/17)
Spark
Shield
Handle
Profile
Roller