User Provisioning For Wps - Technicolor CGA4131 Operation Manual

2. Personal Identification Number (PIN) method:
This method is the mandatory baseline mode and every device must support it. The Wi-Fi
Direct specification supersedes this requirement by stating that all devices with a keypad or
display must support the PIN method
Enter the client device's PIN number here and click the Register button. If the WPS LED on
the front panel flashes, press the start button in the client device software. If the client device
software asks the target SSID, enter the current SSID shown on the WebUI. If a wrong PIN
number was input, the client device will not be connected.
3. External Registrar (ER) method:
If the client device software supports the ER method, enter the gateway's SSID and PIN
number in the client device software, and then press the start button. In this method, no
action is required, and the WPS LED on the front panel will start to blink automatically. When
the gateway detects an attempt with an invalid PIN, it doubles the lockout time. If it detects
10 attempted with invalid PIN since booting, the ER method will be disabled permanently.
7.6.1

User provisioning for WPS

Wireless Tab / WPS
Click on the Wireless tab and then click on the WPS control tab. The page displays WPS
setup information. Here user can set and display WPS parameters including the Access
Point PIN and Connection Method (Push Button/ PIN Number).
3/6/2018 Proprietary and Confidential - Technicolor 71