Remove The Fresh Water Drain Hose - Kärcher AP 100 M Service Manual

5.10.3Remove the fresh water drain hose.

Note
The fresh water drain hose is also used as a fill level
display.
Preliminary tasks:
Empty the fresh water reservoir.
Lay the device on the side.
1 Fresh water tank
2 Drainage hose for fresh water
Loosen the hose clamp on the fresh water drain
hose.
Remove the fresh water drain hose.
Installation in reverse order
Note
After the assembly, check all hoses for leaks.
5.10.4Clean/replace the water filter
If the filter sieve in the water filter is dirty, it must be
cleaned or replaced if necessary.
1 Fresh water tank
2 Filter pot
3 Waterfilter
Empty the fresh water reservoir.
Unscrew the filter cup.
Clean/replace the filter insert.
Place the cleaned or new filter insert in the filter
cup and tighten the screws of the filter cup.
Fill up fresh water reservoir.
Note
After the installation, check the water filter for leaks.
English 5.906-508.0 Rev. 00 (11/10)
41