Scrubbing Brush (Accessory) - Kärcher AP 100 M Service Manual

5.13 Scrubbing brush (accessory)

A scrubbing brush can be attached as an accessory
to clean severely contaminated surfaces.
5.13.1Connect the scrubbing brush
1 Suction pipe
2 Scrubbing brush
Attach the scrubbing brush to the suction pipe.
1 High pressure hose
2 Hose switch
3 Handle
4 Trigger gun
Install the hose holder and the handle on the suc-
tion pipe.
Connect high pressure hose to the hand spray
gun.
48
English 5.906-508.0 Rev. 00 (11/10)
5.13.2Replace the vacuum lips of the scrubbing
brush
1 Fastening screw
Loosen the fastening screw.
1 Front vacuum lip
2 Rear vacuum lip
3 Running roller
Remove the caster.
Remove the vacuum lips from the bottom.
Installation in reverse order
Note
The structured side of the vacuum lip must point out-
wards.