Wastewater Reservoir; Removing The Wastewater Reservoir; Remove The Drain Hose For Wastewater - Kärcher AP 100 M Service Manual

5.2 Wastewater reservoir

5.2.1 Removing the wastewater reservoir

Preliminary tasks:
Empty the dirt water reservoir.
Remove operating panel.
1 Fastening screw
2 Drainage hose for fresh water
Remove the detergent reservoir.
Unscrew the rear fastening screws.
Pull fresh water drain hose off of the wastewater
reservoir.
1 Fastening screw
Unscrew locking screws.
Remove wastewater reservoir toward the rear.
Installation in reverse order
Note
After the assembly, check all hoses for leaks.
24
English 5.906-508.0 Rev. 00 (11/10)

5.2.2 Remove the drain hose for wastewater

Preliminary tasks:
Remove the wastewater reservoir.
1 Hose clip
2 Dirt water discharge hose
Place the wastewater reservoir upside down.
Loosen the hose clamp from the wastewater drain
hose.
Pull the wastewater drain hose off of the wastewa-
ter reservoir.
Installation in reverse order
Note
After the assembly, check all hoses for leaks.