Buderus G315 Assembly, Maintenance And Operating Instruction page 18

Installation of Insulation & Boiler Jacket Panels
• Arrange the insulation blanket according to
Figure 28.
• Push the insulation between the boiler feet.
Cut-out provisions are made in the blanket for
this purpose.
• Install the rear insulation piece with the return
connection cut-out upward on the vent
connection (Fig. 28).
• Secure the rear insulation piece with two tension
springs to the upper support bracket.
• Close the slit in the rear insulation below the
vent connection with a tension spring.
• Slide the insulation piece with cut-out onto the
folded edge of the front upper support bracket
(Fig. 29).
Installation of boiler jacket panels.
• Hang the side panels at the knock-outs on the
support brackets and slide them forward until
fully engaged with the support bracket slots
(Fig. 29).
• Secure the bottom of the side panels to the lower
support brackets with two sheet metal screws
(Fig. 29).
• Place the front top cover between the side panels
with its knock-out aligned with the support
bracket (Fig. 30).
• Secure the front top cover on the back side with
two screws to the side panels (Fig. 30).
Rear insulation piece
Tension springs
Fig. 28
Side panel
Insulation piece
Fig. 29
Front top cover
Fig. 30
9
Insulation blanket
Screws
Screw
Knock-out
Cross piece
Side panel
17